E2SS

Cylinder Sensor

E2SS

Mounts to Any Type of Cylinder

* Information in this page is a reference that you created on the basis of information in the product catalog before the end of production, may be different from the current situation, such as goods for / supported standards options / price / features of the product. Before using, please check the compatibility and safety system.

last update: May 23, 2013

Model		Standard Models E2SS-M Series		Magnetic Field Immune Models * E2SS-W Series
Model		E2SS-MC1(-M1J)	E2SS-MB1(-M1J)	E2SS-WC1-P1	E2SS-WB1-P1
Power supply voltage		10 to 30 VDC (including ripple (p-p): 10 %)
Detection sensitivity (magnetic sensitivity)		2.8 mT max.
Current consumption		15 mA max.
Hysteresis		1 mm max.
Repeat accuracy		±0.1 mm max.
Pass speed		10 m/s max.		1 m/s max.
Switching frequency		1 kHz max.		20 Hz max.
Control output	Switching capacity	150 mA max.		100 mA max.
Control output	Residual voltage	2 V max. (Load current: 150 mA, Cable length: 2 m)		2 V max. (Load current: 100 mA, Cable length: 2 m)
Indicator		Operation indicator (yellow)
Operation mode		NPN open-collector, NO (normally open)	PNP open-collector, NO (normally open)	NPN open-collector, NO (normally open)	PNP open-collector, NO (normally open)
Protective circuits		Power supply reverse polarity protection, output reverse polarity protection, and load short- circuit protection
Ambient temperature		Operating/Storage: -25 to 70°C (with no icing or condensation)
Ambient humidity		Operating/Storage: 35% to 95% (with no condensation)
Insulation resistance		50 MΩ min. (at 500 VDC) between charged parts and case
Dielectric strength		500 VAC, 50/60 Hz for 1 min between charged parts and case
Vibration resistance (endurance)		10 to 55 Hz with 1.0-mm double amplitude for 2 hours each in X, Y, and Z directions
Shock resistance (endurance)		300 m/s² 10 times each in X, Y, and Z directions
Degree of protection		IEC 60529 IP67
Connection method		Blank: Pre-wired (standard cable length: 2 m) -M1J: Pre-wired M12 connector (cable length: 0.3 m)		M12 connector
Weight (when packed)		Pre-wired models: Approx. 35 g Pre-wired M12 connector models: Approx. 30 g		Approx. 25 g
Materials		Case: PP, Cable: PUR		Case: PA, Connector: PA
Accessories		Instruction Manual, cable clip (one)		Instruction Manual, mounting screw (one)

* These models prevent malfunction in environments in which AC welding is being performed.
The Sensor will hold the ON or OFF control output condition when subjected to an AC magnetic field of 50 to 60 Hz and
10 to 100 mT.
When the field subsides, the Sensor returns to normal operation. (Standard models will malfunction under magnetic
field noise of approximately 1 mT or higher.)

last update: May 23, 2013

Product Category

Sensors
- Proximity Sensors
  - Discontinued
    - E2SS

Top of page